Drum stools

Drum stoolscome in all kinds of designs. This starts with a simple stool that you can simply sit on. This increases to an ergonomic seat with a swiveling seat pin and extra locking on the adjusting screw. If you are just starting to play drums as a child, the first one is more than enough. You adjust it once in height and then sit down when you want. However, there are several drummers in the house who use 1 drum set. Then we would recommend a revolving stool. This is much easier to adjust in height than the most simple variant. In addition, there is a big difference in the seat. The most famous drum stools are those with a round seat. But there are also stools with a more saddle-shaped seat. This gives the thighs more room to move freely. This can provide more speed in the pedals. In some cases these stools can also be supplied with an extra back support. In all cases it concerns a stool with a sturdy 3-legged underneath.

Cymbal stands

Cymbal standsalso come in several variants. The two biggest differences are the straight tripods and the tripods with a boom arm. The straight tripod is a tripod that is adjustable in height in two or 3 parts. On top is a pin where you can attach the pelvis. Slightly underneath is a hinge that allows you to place the pelvis at different angles. This way each drummer can determine his own angle. With a tripod with a boom arm, there is an extra extension at the location of the hinge. With this extension you can go even more ways. This way you can place your cymbals even more precisely. Where otherwise you sometimes get stuck with the hardware getting in the way everywhere, you now have more freedom of movement. This way you can build up the setup that works best for you.

Snare drum stands

Snare drumsstands are very important to a drummer. You usually use the snare drum the most of all your drums. It is important that it is perfectly adjusted before you start playing. One drummer wants his snare drum completely level and the other as at an angle as possible. It is important that no matter how slanted it is, it is stable. Of course, no drummer is happy when your snare drum suddenly falls in the middle of your performance. Always pay attention to how wide the foot can be folded out when buying a snare drum stand. In addition, it is nice to know how to adjust the 3 arms on which the snare drum rests. It is easiest if you can adjust it with a turning mechanism at the bottom. This way you can always adjust it slightly in between two songs.

Drum pedals

Drum pedalsis an important category within hardware. Where you simply have good and less good quality with a lot of hardware. Is this something your game actually has to do with. To start with, you always get away with a simple basic pedal. But as you progress as a drummer you will notice that you get different wishes. Should a pedal react faster or less quickly. You can partly adjust this, but the pedal certainly has an influence on this. And in addition to those differences, you also have the so-called double bass pedals. These are two foot pedals with one in the original position. The other, on the other hand, is placed next to the hi-hat pedal. The beaters are both in the middle of the bass drum. So you can play twice as fast as with a single pedal. You see this a lot in certain styles. Think of: hard rock, metal and other harder music styles.

Other clamps and hardware.

This category is mainly intended for the drummer who thinks: “I wish…!”. The chance that it is possible is very present. Within the hardware there are so many small parts and clips. That there is always something to be found to attach an extra pelvis to something. Or just put that Tom in a different place. Multi-clamps always provide the opportunity to attach more than you initially think.

Common terms.

Drum beater: Hammer on your kick pedal.

Lugs: The tube where the tensioning screw goes to tension the sheet.

Clutch: The metal connector on which you put the top pelvis of your hi-hat.

Shells: the boilers of the drums. The metal or wooden round shape on which the sheets are attached.

Span edges: The edges that press on the sheets so that they stay in place and can be tuned.